Phoenix Court Builders
A finished, playable court with the right base, drainage, and surface for Arizona conditions.
What Goes Wrong
A base laid without a proper slope assessment leaves standing water on the playing surface after rain.
The drainage gradient is engineered into the base design from the start, moving runoff clear of the court.
Caliche soil common across Phoenix resists compaction and causes slab movement if the sub-base is not prepared correctly.
An on-site evaluation identifies caliche depth and determines the correct sub-base preparation before any base is specified.
A standard acrylic coating not rated for Phoenix UV cycles fades and degrades within a season, leaving the surface unplayable.
The builder selects a UV-stable acrylic coating matched to Phoenix heat cycles, applied in the specified number of layers.
A playing area without adequate runoff clearance forces players into fences or walls, creating a safety hazard on every point.
The layout targets a 10-foot runoff clearance on each end of the 20-by-44-foot playing area as a baseline planning figure.
Scope of Work
From the first ground check to the final net post, every stage is part of the scope.
The ground is assessed for slope, caliche, and drainage before any base work begins, so the finished court sits level.
Sub-base compaction and slab pour are completed to the correct spec, with cure time observed before coating starts.
UV-stable acrylic is applied in multiple layers over the cured slab, giving the court its playing surface and color.
Non-volley zone, service boxes, baseline, and sidelines are marked to regulation layout on the finished surface.
Posts are set into the slab at the correct anchor depth and spacing, ready for a regulation net.
Chain-link or welded wire fence around the court perimeter.
Additional grading or channel drainage for sloped or tight sites.
Crack repair and recoating for worn or damaged existing courts.
Multi-court layouts for shared community or school sites.
Why Choose Us
Every job is handled by a local builder who knows Phoenix soil and sun conditions firsthand.
The builder visits the site to check soil, slope, and drainage before a single figure is written down.
Base prep, surfacing, drainage, and line marking each appear as separate line items, nothing is bundled or hidden.
The builder assesses UV exposure and caliche depth at your specific site, then specs the base and coating accordingly.
Grading, base, coating, striping, and net post installation are all coordinated through one local builder, not split across trades.
Surface level, line accuracy, and net post alignment are checked together with you before the job is considered complete.
The service covers home lots, HOA common areas, and school facilities across the Phoenix metro area.
How It Works
01
Tell us the location and intended use, and we’ll arrange a local builder to contact you and schedule the on-site visit.
02
The builder assesses slope, soil, and sun exposure, then delivers an itemised estimate covering every stage of the build.
03
The builder completes grading, base, coating, striping, and net post installation, then walks through the finished court with you.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Small backyard pickleball court | $15,000-$25,000 |
| Standard outdoor pickleball court | $20,000-$50,000 |
| Premium outdoor pickleball court | $40,000-$75,000 |
We’ll arrange a local court builder to assess the ground, account for Arizona conditions, and put the full scope in writing.